After POD systems and sub-mods appeared on the vape market, many vapers slightly reconsidered their attitude towards the devices they used before. And many made the decision to put on the shelf a box mod with a tank and a mech mod with a drip. But, as it turned out, it’s not that simple, because many people want to get easy maintenance, autonomy and good taste at the same time. And quite suddenly on the market appeared pod-mods that run on two batteries 18650, with a capacity of 200 + Watts and with the ability to use them as traditional boxmods. And one of these devices was Rincoe Manto Max 228W AIO Mod Pod Kit, looking at which it is not clear whether it is a sub-mod or original box mod, but in any case, the device is interesting and functional.

General Info

Rincoe Manto Max 228W AIO Mod Pod Kit is a pod mod that runs on two rechargeable 18650 batteries equipped with a reliable performance chipset and is designed to run on vaporizers, standard atomizers or RDTA cartridge. canadian vape shop mississauga The design of the new device can be called rx-like, but this is not too bad, as the ergonomics of the device is quite decent. The sub-mod is equipped with a productive chipset that allows you to use it in variwatt and heat control modes. Depending on the vaper’s preferences, you can use a standard cartridge for vaporizers, an adapter for atomizers with a 510-m connector or RDTA cartridge for independent installation of spirals. You can buy the Rincoe Manto Max 228W AIO Mod Pod Kit in three colors: gray, rainbow, and black.

Kit

It is worth paying tribute to the manufacturer, who completed the new device very decently, it is unlikely that anyone will have any complaints about the kit. In the black cardboard box the vaper waits:

Manto Max 228W Mod battery pack;

Manto Max Pod 8 ml cartridge;

Single mesh coil 0.3ohm (50-70W) vaporizer;

Dual mesh coil vaporizer 0.2ohm (60-75W);

Adapter to use atomizers with 510 connector;

USB cable;

User Manual;

Warranty card.

Manto Max 228W Mod Battery Pack

It would seem that a year ago no one could think about how sub-mods would work on interchangeable batteries, and that you could get quite a versatile option that can replace both sub-mod and box-mod, could not be dreamed about. But the developers did their best to realize such ideas. And one of the brightest examples of this is Rincoe Manto Max 228W AIO Mod Pod Kit. We can safely say that the device is unconventional, but no less interesting.

Rincoe Manto Max 228W AIO Mod Pod Kit by its design strongly resembles the legendary ryksa – the same strange triangular, but very convenient and practical form. An important plus of this device is that it is quite compact 111*40.3*37 mm, and weighs only 149 grams. The body is made of zinc alloy and plastic, but the range of colors is small only three colors.

The Rincoe Manto Max 228W AIO Mod Pod Kit has a maximum power output of 228 watts, and it is provided by two traditional 18650 batteries installed under the flip cover. The batteries can be charged with 2A current using the micro-USB connector located on the front panel.

The device uses a proprietary Mechman Chip chipset with a response time of only 0.002 seconds. The functionality is quite standard Varivatte and thermal control, but the board is able to work with windings from 0.08 ohms. The Rincoe Manto Max 228W AIO Mod Pod Kit has a small color display, with a standard set of information about the operation of the device.

Картридж Manto Max Pod

It is worth paying tribute to the developers of Rincoe, who decided to provide for all possible options for the device with cartridges and adapter. The cartridge in the battery pack is held by magnets, so the process of its replacement takes only a couple of seconds. The manufacturer offers a standard cartridge, an RDTA cartridge and an adapter for using atomizers with a 510 connector.

The standard cartridge is designed for installation of interchangeable brand vaporizers, which are represented by three kinds at the moment, and all of them are mesh type with 0,3/0,2/0,15 Ohm resistance. If you want, you can additionally buy a serviced base. Blowing control is not provided.

Quite original solution is the ability to replace the cartridge on the vaporizers on the RDTA cartridge (Aegis Boost had a similar solution). This cartridge uses a dual helix stack-less base, which is very easy to maintain, with the bottom blowing. You have to buy this cartridge separately.

If a vaper wants to use Rincoe Manto Max 228W AIO Mod Pod Kit as a standard box mod, he just needs to take out the cartridge and install an adapter instead (fortunately, it is included in the kit). The size of the adapter is such that you can safely install tanks or vodka with a diameter of up to 26 mm.

Filling the standard cartridge on the vaporizers will not cause difficulties on the top surface there is a cap which you can open and fill 8 (!!!) ml of liquid.

Conclusions and impressions

At the moment Rincoe Manto Max 228W AIO Mod Pod Kit has not become a revolutionary device, as the market has already had a device of this format (from Smok), but certain chips in it are still there. Each vaper who decides to buy Rincoe Manto Max 228W AIO Mod Pod Kit will get quite a versatile device that can please with its design and variability.

Advantages and disadvantages

Disadvantages

Lack of blowing adjustment in the cartridge on the vaporizers;

RDTA cartridge must be purchased separately;

Vaporizers only sabot.

Advantages

Ergonomic design;

Fast charging;

Use of 2 Batteries 18650;

Good performance;

Easy operation;

Large volume cartridge;

Possibility to install RDTA cartridge;

Convenient installation of spirals in RDTA;

Bottom blow;

Convenient refilling.